ComAp InteliLite AMF25 User Manual

InteliLite Global Guide
382
Setpoint group CM-Ethernet Related FW 1.9.0
Range [units] 0..31 characters [-]
Default value private Alternative config NO
Step [-]
Comm object 24334 Related applications AMF, MRS
Config level Standard
Setpoint visibility
Only if relevant module is installed + conditioned by the setpoint SNMP Agent (page
381)
Description
SNMP Community String for writing and reading.
SNMP WR Community String
6 back to List of setpoints
Setpoint group CM-Ethernet Related FW 1.9.0
Range [units] SNMPv1 Trap / SNMPv2 Not / SNMPv2 Inf [-]
Default value SNMP v1 Trap Alternative config NO
Step [-]
Comm object 24136 Related applications AMF, MRS
Config level Standard
Setpoint visibility Only if relevant module is installed
Description
This setpoint adjusts type of SNMP traps.
SNMP Trap Format
6 back to List of setpoints
Setpoint group CM-Ethernet Related FW 1.9.0
Range [units] Valid IP address [-]
Default value DISABLED Alternative config NO
Step [-]
Comm object 24294 Related applications AMF, MRS
Config level Standard
Setpoint visibility Only if relevant module is installed
Description
IP address 1 for receiving SNMP Traps. Leave this setpoint blank if SNMP traps should not be send.
SNMP Traps IP Address 1
6 back to List of setpoints

ComAp InteliLite AMF25 Specifications

General

Inputs	8 binary inputs
Outputs	8 binary outputs
Power Supply	8-36 V DC
Communication	RS232, RS485
Operating Temperature	-20°C to +70°C
Supported Generators	Diesel, gas
Controller Type	Automatic Mains Failure Controller
Protection	IP65