ComAp InteliLite AMF25 User Manual

InteliLite Global Guide
377
Setpoint group CM-Ethernet Related FW 1.9.0
Range [units] 0..31 characters [-]
Default value airgate.comap.cz:9925 Alternative config NO
Step [-]
Comm object 24368 Related applications AMF, MRS
Config level Standard
Setpoint visibility Only if relevant module is installed
Description
This setpoint is used for entering the domain name (e.g. smtp.yourprovider.com) or IP address (e.g.
74.125.39.109) or number of port (with colon like a first mark) of the SMTP server. Ask your internet provider
or IT manager for this information.
Note: You may use also any public SMTP server which does not require connection over SSL/TLS
channels. If the device is connected to AirGate the AirGate SMTP server at "airgate.comap.cz" may be
used. Ports 25 and 9925 are supported. After controller connects to AirGate for the first time (or with new
public IP address), it may not be able to send emails for first 5-10 minutes.
SMTP Server Address
6 back to List of setpoints
Setpoint group CM-Ethernet Related FW 1.9.0
Range [units] 0..31 characters [-]
Default value [-] Alternative config NO
Step [-]
Comm object 24367 Related applications AMF, MRS
Config level Standard
Setpoint visibility Only if relevant module is installed
Description
Enter an existing email address into this setpoint. This address will be used as sender address in active e-
mails that will be sent from the controller.
Note: It is not needed to enter an existing email address, nevertheless valid email format needs to be
followed.
IMPORTANT: This item is obligatory when emails are configured.
SMTP Sender Address
6 back to List of setpoints

ComAp InteliLite AMF25 Specifications

General

Inputs	8 binary inputs
Outputs	8 binary outputs
Power Supply	8-36 V DC
Communication	RS232, RS485
Operating Temperature	-20°C to +70°C
Supported Generators	Diesel, gas
Controller Type	Automatic Mains Failure Controller
Protection	IP65