InteliLite Global Guide
378
Setpoint group CM-Ethernet Related FW 1.9.0
Range [units] FIXED / AUTOMATIC [-]
Default value AUTOMATIC Alternative config NO
Step [-]
Comm object 24259 Related applications AMF, MRS
Config level Standard
Setpoint visibility Only if relevant module is installed
Description
The setpoint is used to select the method how the ethernet connection is adjusted.
DISABLED: The Ethernet connection is fixed by means of the setpoints IP Addr, NetMask, GateIP,
DNS IP Address.
This method should be used for a classic Ethernet or internet connection. When this type
of connection opens, the controller is specified by its IP address. This means that it
would be inconvenient if the IP address were not fixed (static).
ENABLED: The Ethernet connection setting is obtained automatically from the DHCP server. The
obtained settings are then copied to the related setpoints. If the process of obtaining the
settings from the DHCP server is not successful, the value 000.000.000.000 is copied to
the setpoint IP address and the module continues to try to obtain the settings.
IP Address Mode
6 back to List of setpoints
Setpoint group CM-Ethernet Related FW 1.9.0
Range [units] Valid IP address [-]
Default value 192.168.1.254 Alternative config NO
Step [-]
Comm object 24376 Related applications AMF, MRS
Config level Standard
Setpoint visibility
Only if relevant module is installed + conditioned by the setpoint IP Address Mode
(page 378)
Description
The setpoint is used to set the address when you are in static mode.
If IP Address Mode (page 378) is FIXED this setpoint is used to adjust the IP address of the ethernet
interface of the controller. Ask your IT specialist for help with this setting.
If IP Address Mode (page 378) is AUTOMATIC this setpoint is inactive. The IP address is assigned by the
DHCP server.
IP Address
6 back to List of setpoints
To Next Page
Loading...
Need help?
General
