Comau e.DO - Page 29

ROBOT CONFIGURATION CUSTOMIZATION
29
Comau Robotics Product Instruction
Remove the e.DO Gripper from the related packaging, proceeding as indicated below:
– The e.DO Gripper is packed in a normal cardboard box with pressure lock; no
special tools are required to remove the packaging;
– remove the packaging paying particular attention not to damage the contents;
– make sure that all the components indicated in the previous Fig. 3.7 are present
inside the package;
– after removing the packaging, make sure the e.DO Gripper does not show signs of
damage during transport; if it does, do not install the e.DO Gripper and contact the
Comau Service Centre (see
Chap.5. - How to contact the Comau Service Center
on page 59);
– the packaging materials must be kept out of reach of children, as they are potential
sources of danger.