Commodore 128D - Page 186

The LOAD and
RUN Commands
SAVEing on Cassette
If you are using a Datassette to store your program, insert a blank
tape in the recorder, rewind the tape (if necessary) and type:
SAVE "PROGRAM NAME" HI 11IITM
Once a program has been SAVEd, you can LOAD it back into the
computer's memory and RUN it anytime you wish.
LOADing and RUNning from Disk
To load your program from a disk, type:
LOAD"PROGRAM NAME",8 HUBE
Again, the 8 indicates to the computer that you are working with a
diskdrive.
To RUN the program, type RUN and press <RETURN>.
LOADing and RUNning from Cassette
To LOAD your program from cassette tape, type:
LOAD ''PROGRAM NAME" III MINI
If you do not know the name of the program, you can type:
and the next program on the tape will be retrieved.
You can use the counter on the Datassette to identify the starting
position of the programs. Then, when you want to retrieve a pro
gram, simply wind the tape forward from 000 to the program's start
location, and type:
LOAD!
In this case, you don't have to specify the PROGRAM NAME; your
program will load automatically because it is the next program on
the tape.
NOTE: During the LOAD process, the program being LOADed
is not erased from the tape; it is simply copied into the com
puter. However, LOADing a program automatically erases any
BASIC program that may have been in the computer's memory.
To RUN the program, type RUN and press <RETURN>.
\ '
u
178
USING C64 MODE—Storing and Reusing Your Programs in C64 Mode