Compal JHL90 - Exit Saving Changes; Exit Discarding Changes

JHL90 Service Manual
10.2.3 Exit
Phoenix SecureCore(tm) Setup Utility
Exit Saving Changes
Exit Discarding Changes
Load Setup Defaults
Discard Changes
Save Changes
F1 Help ↑↓ select Item F5/F6 Change Values F9 Setup Defaults
Esc Exit ←→ select menu Enter Select 4 Sub-Menu F10 Save and Exit
Exit Saving Changes
Allows the user to save changes to CMOS and reboot system. The following message is prompted
when user press “Enter” on the item.
Setup Confirmation
Save configuration changes and exit now?
[Yes] [No]
Yes: Exit SETUP and reboot
No: Return to SETUP
Exit Discarding Changes
Allows the user to discard changes to CMOS and reboot system. The following message is
prompted when user press “Enter” on the item.
Setup Warning
Configuration has not been saved!
Save before exiting?
[Yes] [No]
2-18