Compal JHL90 - Page 41

JHL90 Service Manual
CMD DATA Description return
Lid open A5h
Lid closed A6h
External device plugged A7h
External device removed A8h
Bluetooth wake up event A9h
56h Input device event AAh
Scr expand event ABh
Display change (LCD, CRT) ACh
Cpu fast event ADh
Cpu slow event ADh
Battery life in critical low state (LLB) B2h
Battery life in low power state (LB) B3h
Battery Plug-In B5h
Docked in request BAh
Undock request BBh
Power button pressed C2h
AC power plug-in C7h
AC power plug-out C8h
Modem Ring In CAh
PME signal active CEh
Sleep button event D1h
57h None Module identification
Bit0: Main HDD exist
Bit1: Int. FDD exist
Bit2: CD_ROM exist
Bit3: 2nd HDD exist
Bit4: LS120 exist
Bit5: External FDD
Bit6: CRT plug In/Out:0=Out, 1=In
Bit7: ODD power on/off
One byte
58h 0x00-
0xFF
Set flat panel type None
59h System state notification None
60h Enable FnKey of sticky key function
(Support by ToshibaPowerSaver)
None
61h Disable FnKey of sticky key function
(Support by ToshibaPowerSaver)
None
62h Fn key down (Support by
ToshibaPowerSaver)
None
63h Fn Key Up (Support by
ToshibaPowerSaver)
None
64h Enable scancode for test button None
65h Disable scancode for test button None
70h Sticky key mode enable (for no AP
support used)
None
71h Sticky key mode disable (for no AP
support used)
None
76h Enable FAN speed full on None
77h Disable Fan speed full on None
78h Disable FAN fine tune function None
79h Enable FAN fine tune function None
90h One touch button application allow to
send scan code
(
use
r
button
)
if user
None
2-25