Compal JHL90 - Page 42

JHL90 Service Manual
CMD DATA Description return
pressed
91h One touch button application don’t
allow to send scan code (user button) if
user pressed
None
94h Mute on None
95h Mute off None
9Ah Disable AC power source None
9Bh Enable AC power source None
9Ch Enable LID switch resume function None
9Dh Disable LID switch resume function None
9Eh Disable Internal keyboard. None
A2h System shutdown None
A3h System enter beep mode for battery LB
state in CMOS setup
None
A4h System enter quiet mode for battery LB
state in CMOS setup
None
A5h Fan control by EC None
A8h Fan control by OS None
ADh Wireless LAN wakeup enable None
AEh Wireless LAN wakeup disable None
B1h System into standby None
B2h Resume from standby None
B3h LLB resume from S3 (enable) None
B4h LLB resume from S3 (disable) None
B5h VGA suspend enable None
B6h VGA suspend disable None
B7h Modem ring enable None
B8h Modem ring disable None
B9h PME enable None
BAh PME disable None
BBh In S4 status None
BCh Resume form S4 status None
BDh RTC wake up enable None
BEh RTC wake up disable None
C1h Force battery pack auto learning
(Support in battery learn mode)
None
C2h Disable battery pack learning (Support
in battery learn mode)
None
C3h SMI/SCI Trigger event enable None
C4h SMI/SCI Trigger event disable None
CBh PCMCIA suspend disable None
CCh PCMCIA suspend enable None
CDh Wake up LAN disable None
CEh Wake up LAN enable None
D0h Disable IRQ1 None
D1h Enable IRQ1 None
D2h Beep alarm 200mS None
D5h PCMCIA reset on None
D6h PCMCIA reset off None
D7h Battery stop charge enable None
D8h Battery stop charge disable None
D9h Set system flag None
DAh Clear system flag None
2-26