Comtech EF Data LPOD Series - Page 100

Low Power Outdoor (LPOD) Amplifier/Block Up Converter (BUC)
Revision 15
Ethernet Interface Operation 4–18 MN-LPOD
System Account Access Information
Name fields can be any alphanumeric combination with a maximum length of
10 characters.
Password fields can be any alphanumeric combination with a maximum
length of 10 characters.
Name
Description
Read Only Name
The factory default is monitor.
Read Only Password
The factory default is 1234.
Read/Write Name
The factory default is opcenter.
Read/Write Password
The factory default is 1234.
Admin Name
The factory default is comtech.
Admin Password
The factory default is comtech.
SMTP Server
Enter the mail server IP address from where you want to send the e-mail.
SMTP Domain Name
The Administrator can assign the SMTP Domain Name. This is required if you
wish to use the e-mail feature of the ‘Home | Support’ Page (Sect. 4.5.1.3).
Enter the domain of the e-mail server (usually found to the right of the @
symbol in an e-mail address).
SMTP Domain Destination
The Administrator can assign the SMTP Domain Destination. This is required if
you wish to use the e-mail feature of the ‘Home | Support’ Page (Sect.
4.5.1.3).
Enter the e-mail recipient name (usually found to the left of the @ symbol in an
e-mail address).
Click [Submit Access] to save any changes.
Click [Reset] to restore the fields to the default setting.
Webpage Timeout
The Webpage Timeout sets the time period that can pass before the HTTP Interface pages time
out.
Use the drop-down list to select 5 minutes (default) or 8 hours.
Click [Submit].
The Status | Status page automatically refreshes once every ten seconds, and
resets the webpage timeout counter.