Low Power Outdoor (LPOD) Amplifier/Block Up Converter (BUC)
Revision 15
System Connectors, Installation, and Startup 2–23 MN-LPOD
2.5 LPOD Power Setting
FOR SAFETY REASONS, NEVER TURN THE UNIT ON WITHOUT PROPER
WAVEGUIDE TERMINATION ON THE ‘J2 | RF OUT’ PORT. YOU M AY OTHERWISE
BE EXPOSED TO DANGEROUSLY HIGH ELECTROMAGNETIC LEVELS.
The LPOD does not have a ‘Power On/Off’ switch. You may power ON the unit by connecting the
‘J3 | POWER IN’ connector to the appropriate prime power source. The Mute or Transmit status
of the SSPA automatically comes up in the last stored state (factory default = Transmit on, not
muted).
To Next Page
Loading...
