Comtech EF Data LPOD Series - Page 155

Low Power Outdoor (LPOD) Amplifier/Block Up Converter (BUC)
Revision 15
Serial Interface Operation 5–35 MN-LPOD
Parameter
Type
(* indicates
End-of-Life)
Controller-to-Target
Instruction Code and
Qualifier
Arguments
for Command
or Query
Description of Arguments
(Note that all arguments are ASCII numeric codes from 48 to 57)
Target-to-Controller
(see Description of
Arguments)
Command Query
Response to
Command
Response
to Query
Retrieve Next 5
Unread Stored
Events
(Cont)
24) SWIT
INFO CODES REPORT AS FOLLOWS:
0=Power Off; 1=Power On; 2=Log Cleared; 3=Global Config Change;
4=Redundancy Config Change
ddmmyy=Date in day/month/year format
hhmmss=Time in hour:minutes:seconds format
NOTES:
1) If less than 5 events are retrieved, the remaining positions are padded with
zeros.
2) If there are no new events, the response is RNE*.
3) A Global Config Change is defined as any time a command is successfully
executed.
4)
A query does not set the status change flag. The status change flag is
cleared after being read. No other events toggle a status change.
Retrieve Next 5
Unread Stored
Statistics
N/A
RNS?
75 bytes
Query only.
Returns the oldest 5 unread stored statistics entries in the reply format: {CR}Sub-
body{CR}Sub-body{CR}Sub-body{CR}Sub-body{CR}Sub-body, where:
Sub-body= ddmmyyhhmmssaaa.abbb.bccc.cdd.ddefghhh.hiii.i
ddmmyy=day/month/year
hhmmss=hour:minute:second
aaa.a=Operating Temperature (e.g., +40.0)
bbb.b=Amp Temperature (e.g., +40.0)
ccc.c=RF Power output
dd.dd=Attenuation Setting
e=Amp On/Off
f =Mute On/Off
g=Online/Offline Status
hhh.h=LNB Current (mA)
iii.i=BUC Tuning Voltage
NOTE: If there are less than 5 entries to be retrieved, the remaining positions are
padded with zeros. If there are no new entries, the response is RNS*.
RNS=
RNS={CR}
Sub-
body{CR}S
ub-
body{CR}S
ub-
body{CR}S
ub-
body{CR}S
ub-body