Low Power Outdoor (LPOD) Amplifier/Block Up Converter (BUC)
Revision 15
Ethernet Interface Operation 4–10 MN-LPOD
4. Use the LRS=2 remote command to set the remote access parameter for Ethernet
remote control.
The LRS remote command sets or returns Local or Remote state in the
form x, where x=0, 1, 2, or 3:
• LRS=0 (Local)
• LRS=1 (Serial)
• LRS=2 (Ethernet)
• LRS=3 (Serial+Ethernet) (default value)
To Next Page
Loading...
