Condair EL - Fault Elimination Notes; Resetting Fault Indicators

73Fault elimination
7.4 Notes on fault elimination
– For the elimination of faults set the Condair EL out of operation (see chapter 4.5) and disconnect it
from the mains.
DANGER!
Dangerofelectrichazard!
Make sure the Condair EL is separated from the mains (check with voltage detector) and the shut-
off valve in the water supply line is closed.
– The elimination of faults must be carried out by qualied and well trained professionals only.
Malfunctions relating to the electrical installation must be repaired only by an authorized electrician
or the Condair service technician.
CAUTION!
Electronic components are very sensitive to electrostatic discharge. When carrying out repairs
to the Condair EL, appropriate measures (ESD-protection) must be taken to prevent damage to
electronic components.
7.5 Resetting the fault indication
To reset the error indication (red LED lights and the maintenance and -malfunction indication eld shows
"Fault"):
1. Switch off the Condair EL via the unit switch.
2. Wait approx. 5 seconds, then switch on the Condair EL again.
Note: If the fault has not been eliminated, the fault indication reappears after a short while.