Condair Sigma - Mounting the Humidifier

26 Mounting and installation work
5.3.2 Mountingthehumidier
Dimension Housing size
small medium large
a 175 mm 189 mm 246 mm
b 35 mm 61 mm 52 mm
c 335 mm 490 mm 547 mm
d 130 mm 120 mm 180 mm
e 75 mm 120 mm 180 mm
Procedure
1. Mark the attachment point "A" on the wall.
2. Drill hole for attachment point "A" (diameter: 8 mm, depth: 40 mm).
3. Insert the supplied plastic plug, and tighten the screw until the distance between the wall and the
screw head is 4 mm.
4. Unlock the two screws xing the front panel to the unit, then remove the front panel.
5. Hang up the unit onto the screw and adjust it horizontally and vertically using a spirit level. Then,
mark the xing points "B".
6. Drill the holes for the xing points "B" (diameter: 8 mm, depth: 40 mm).
7. Insert the supplied plastic plugs, and tighten the screws until the distance between the wall and the
screw head is 4 mm.
8. Hang the unit up onto the screws. Before tightening the screws, readjust the unit with the spirit level.
9. Reattach the front panel and secure it with the two screws.
d
e
b
c
a
A
B
B