-
-
-
- 107 -
-
-
-
Figure
Figure
Figure
Figure 15
15
15
15 -
-
-
- 5
5
5
5 IBP
IBP
IBP
IBP PRESSURE
PRESSURE
PRESSURE
PRESSURE ZERO
ZERO
ZERO
ZERO
Note
Note
Note
Note
It
It
It
It is
is
is
is the
the
the
the responsibility
responsibility
responsibility
responsibility of
of
of
of the
the
the
the user
user
user
user to
to
to
to ensure
ensure
ensure
ensure that
that
that
that a
a
a
a zero
zero
zero
zero procedure
procedure
procedure
procedure has
has
has
has recently
recently
recently
recently been
been
been
been done
done
done
done on
on
on
on the
the
the
the
transducer,
transducer,
transducer,
transducer, otherwise
otherwise
otherwise
otherwise there
there
there
there will
will
will
will be
be
be
be no
no
no
no recent,
recent,
recent,
recent, valid
valid
valid
valid zero
zero
zero
zero value
value
value
value for
for
for
for the
the
the
the instrument
instrument
instrument
instrument to
to
to
to use,
use,
use,
use, which
which
which
which
may
may
may
may result
result
result
result in
in
in
in inaccurate
inaccurate
inaccurate
inaccurate measurement
measurement
measurement
measurement results.
results.
results.
results.
Zero
Zero
Zero
Zero Calibration
Calibration
Calibration
Calibration of
of
of
of Transducer
Transducer
Transducer
Transducer
Select CH1, the system will zero IBP1. Select CH2, the system will zero IBP2.
Cautions:
Cautions:
Cautions:
Cautions:
Turn off patient stopcock before you start the zero procedure.
The transducer must be vented to atmospheric pressure before the zero procedure.
The transducer should be placed at the same height level with the heart, approximately mid-axially
line.
Zero procedure should be performed before starting the monitoring and at least once a day after
each disconnect-and-connect of the cable.
The
The
The
The prompt
prompt
prompt
prompt information
information
information
information related
related
related
related to
to
to
to zero,
zero,
zero,
zero, take
take
take
take CH1
CH1
CH1
CH1 for
for
for
for example.
example.
example.
example.
■ “ SENSOR OFF, FAIL ”
Make sure that transducer is not off, then proceed zeroing.
■ “ IN DEMO FAIL ”
Make sure that the monitor is not in DEMO mode. Contact service technician if necessary.
■ “ PRESSURE OVER RANGE, FA I L ”
Make sure that the stopcock is vented to atmosphere. If the problem persists, contact service
technician.
■ “ PULSATILE PRESSURE, FA I L ”
Make sure that the transducer is not attached to the patient and that the stopcock is vented to
atmosphere. If the problem persists, contact service technician.
IBP
IBP
IBP
IBP Calibration
Calibration
Calibration
Calibration
Press the IBP PRESSURE CAL IBRATION button on the IBP SELECT menu to call up the IBP
PRESSURE CALIBRATE menu as shown below :
To Next Page
Loading...
Need help?
General
