Contec CMS8000 - Page 76

-
-
-
- 73 -
-
-
-
ARR
ARR
ARR
ARR ANALYSIS
ANALYSIS
ANALYSIS
ANALYSIS Menu
Menu
Menu
Menu
Figure
Figure
Figure
Figure 11-11
11-11
11-11
11-11 ARR
ARR
ARR
ARR ANALYSIS
ANALYSIS
ANALYSIS
ANALYSIS Menu
Menu
Menu
Menu
■ ARR ANAL :Pick "ON" during monitoring. Default set is "OFF".
■ PVCs ALM : pick "ON" to enable prompt message and data record when alarm occurs ; pick "OFF"
to disable the alarm function, and there will be a beside “ PVCs ” .
■ ALM LEV: selectable from HIGH, MED, LOW . Level HIGH represents the most serious case.
■ ALM REC: pick "ON" to enable report printing upon PVCs alarm.
PVCs alarm is activated when the PVCs exceeds set PVCs ALM HI value.
PVCs alarm upper limits:
Max Min Step
PVCs 10 1 1
PVCs
PVCs
PVCs
PVCs alarm
alarm
alarm
alarm and
and
and
and prompt
prompt
prompt
prompt message:
message:
message:
message:
Among physiological alarms, those belonging to the type that the parameter has exceeded the limits
may activate the recorder to automatically output the parameters and related measured waveforms
when the alarms occur on the condition that the alarm record switch in the related menu is On.
Tables below describe the possible physiological alarms, technical alarms and prompt messages
occurring during pvc s measurement.
Physiological alarms:
Message Cause Alarm Level
PVCs TOO HIGH PVCs measuring value is above upper alarm
limit.
User-selectable
Technical alarms:
Message Cause Alarm Level Remedy
PVCs ALM LMT ERR
Functional safety
failure
HIGH
Stop using PVCs alarming
function, notify biomedical
engineer or Our service staff.