Contec CMS8000 Manual

-
-
-
- 74 -
-
-
-
■ ARR RELEARN Pick this item to start a learning procedure. (unusable)
■ ARR ALARM Pick this item to access the ARR ALARM dialog box to s et arrhythmia
alarm parameters.
Set ALM to ON/OFF to enable/disable the alarm function; Set REC to ON/OFF to enable/disable
alarm record function, turn the knob under LEV column to set alarm level to HIGH, MED or LOW.
Figure
Figure
Figure
Figure 11-12
11-12
11-12
11-12 ARR
ARR
ARR
ARR ALARM
ALARM
ALARM
ALARM Menu
Menu
Menu
Menu
You can pick ALL ALM ON to enable alarm function of all arrhythmia types and pick ALL ALM OFF to
disable this function. Likewise, you can pick ALL REC ON to enable recording function for all arrhythmia
types and pick ALL REC OFF to disable this function. Changing the ALM LEV can reset alarm level of
all arrhythmia types to the same value.
■ ARR RECALL Pick this item to review and edit the ARR analysis result.
The latest arrhythmia events ( up to 6 0) are displayed.
Figure
Figure
Figure
Figure 11-13
11-13
11-13
11-13 ARR
ARR
ARR
ARR RECALL
RECALL
RECALL
RECALL Menu
Menu
Menu
Menu
 UP-DOWN Observe other event lists of other page .

Contec CMS8000 Specifications

General

Category	Medical Equipment
Device Name	Contec CMS8000
Type	Patient Monitor
ECG Lead Mode	3-lead or 5-lead
Resolution	800 x 600
Power Supply	AC 100-240V, 50/60Hz
Battery	Rechargeable lithium battery
Operating Temperature	5°C to 40°C
Storage Temperature	-20°C to 55°C
Display	TFT LCD
Screen Size	12.1 inches
Parameters	ECG, RESP, NIBP, SpO2, TEMP, PR
Interface	Ethernet, Nurse call
Humidity	15% to 95% non-condensing
Battery Life	Approximately 4 hours