7-9
7. OPERATING THE ENGINE
Sc2400 Operator’s Manual
IMPORTANT: Avoid engine damage.
●If the engine stalls while operating under load,
immediately restart the engine to prevent over-
heating of the engine.
1. Engage the parking brake securely.
2. Set the range shift lever to the slow
position.
(A) Range shift lever
(a) Slow position
3. Turn off the Power Take Off (PTO)
switch.
●To prevent a possible accident, fully lower all
the implements to the ground.
(A) Power Take Off (PTO) switch
(a) OFF position
4. Restart the engine.
Resume the operation; or run the
engine for 1 to 2 minutes at the lowest
possible running speed, and then
stop the engine.
3. Restarting a Stalled Engine
CAUTION
3014919a
(A)
(a)
3014919b
(A)
(a)
To Next Page
Loading...
