Cub Cadet Yanmar SC2400 User Manual

12-2
12. TIRES, WHEELS AND BALLAST
Sc2400 Operator’s Manual
■ Inflation Pressure
●ALWAYS keep the tires inflated to the correct
pressure. NEVER exceed the recommended
inflation pressure specified in this Operator's
Manual.
Inflation pressure gradually reduces as time elapses.
Check the pressure of each tire before starting the
day's operation and inflate the tires as necessary to
the recommended pressures. If the tire pressures
significantly decrease though the tires are correctly
inflated every day, immediately request your local
Cub Cadet Yanmar dealer to inspect or replace the
problem tire(s).
Before loader work, make sure to check the tire
pressure and, if necessary, inflate the tire(s) to the
recommended pressure.
For the appropriate inflation pressure, refer to the
following table:
■ Wheel Bolt Tightening Torque
Avoid injury:
●ALWAYS keep the wheel bolts tightening to the
specified torque.
●With the wheel bolts loosened, do not drive the
tractor.
Before starting day’s operation, check tightening
torque of each of the tire wheel bolts and, if
necessary, retighten to the specified torque. For the
specified torque, refer to the following table:
WARNING
Tire size Inflation pressure
(psi(kgf/cm
2
))
Inflation pressure when an implement such as the front
loader has been attached to the front of the machine
(psi(kgf/cm
2
))
Front 18 × 8.50 - 10 20 (1.4) 22 (1.5)
Rear
26 × 12.00 - 12 20 (1.4) 22 (1.5)
WARNING
Front wheel bolt (ft•lb (N•m)) 52 - 59 (70 - 80)
Rear wheel bolt (ft•lb (N•m)) 52 - 59 (70 - 80)

Cub Cadet Yanmar SC2400 Specifications

General

Engine Power	24 hp
Transmission Type	Hydrostatic
Fuel Capacity	6.6 gallons
Drive	4WD
PTO	Independent
Hydraulic System	Open center
3-Point Hitch	Category 1
Engine Type	3TNV76 diesel engine