8-4
8. OPERATING THE TRACTOR
Sc2400 Operator’s Manual
3. Start the engine.
Start the engine by referring to “7. OPERATING THE
ENGINE”.
4. Select travel speed.
■ Range Shift Lever
Use the range shift lever to select the speed that best
suits the intended operation.
(A) Range shift lever
(a) SLOW : Used for heavy-load operation.
Low traveling speed.
(b) FAST : Used for light-load operation.
High traveling speed.
■ 4-Wheel Drive Lever
In the 4-wheel drive mode, all the four wheels are
powered to obtain better traction on difficult-to-travel
ground.
The 4-wheel drive lever can be set to the ON or OFF
position only when the tractor is at a standstill.
(A) 4-wheel drive lever
(a) 4-wheel drive mode
(b) 2-wheel drive mode
IMPORTANT: Avoid damage.
●ALWAYS keep the 4-wheel drive lever in the OFF
position when traveling on a paved surface.
●ALWAYS disengage the 4-wheel drive lever when
not needed to prevent premature wear of the front
tires.
●NEVER install tire chains to the front wheels.
Chains will hit and can damage the tractor.
●If disengaging the 4-wheel drive lever is difficult,
stop the tractor, turn the steering wheel right and
left several times. Then attempt to disengage the
4-wheel drive lever again.
●To minimize tire wear, drive in the 4-wheel drive
mode only when absolutely necessary. Driving the
tractor on a paved road in the 4-wheel drive mode
can accelerate wear of the tires.
●To obtain better traction, keep the front tires at the
maximum allowable pressure.
●When the 4-wheel drive lever is in the ON position,
braking will apply to all four wheels.
3014919a
(A)
(a)
(b)
3014904b
(A)
(b)
(a)
To Next Page
Loading...
Need help?
General
