Cub Cadet Yanmar SC2400 User Manual

11-1
11. HYDRAULIC SYSTEM
Sc2400 Operator’s Manual
11. HYDRAULIC SYSTEM
ALWAYS fully release the internal
hydraulic pressure before
disconnecting a hydraulic line.
ALWAYS ensure that all
connections are tight and all the
hydraulic lines, pipes and hoses are free from wear
or damage.
IMPORTANT:
●NEVER operate the 3-point hitch control / cutting
height adjustment lever before the engine has
been sufficiently warmed up.
●If the 3-point hitch control / cutting height
adjustment lever is operated before the engine has
been warmed up, the hydraulic system can be
damaged or develop a failure.
●If abnormal hydraulic noise occurs after the 3-point
hitch has been raised, then misadjustment or failure
of the hydraulic system should be suspected.
In such a case, immediately stop operation and
request your local Cub Cadet Yanmar dealer to
service or repair the tractor.
■ Operating the 3-Point Hitch Control / Cutting Height Adjustment Lever to Raise or
Lower the 3-Point Hitch
Use the 3-point hitch control / cutting height
adjustment lever, when raising or lowering the Mid-
or Rear-mounted implement.
1. Shift the 3-point hitch control / cutting height
adjustment lever to the intended position.
2. Adjust the position stop knob to set the lowest
position of the implement to the desired height.
(A) 3-point hitch control / cutting height
adjustment lever
(B) Position stop knob
(a) Moving the 3-point hitch control / cutting height
adjustment lever forward will lower the
implement.
(b) Moving the 3-point hitch control / cutting height
adjustment lever backward will raise the
implement to raise higher.
WARNING
1. 3-Point Hitch Control System
3014918c
(A)
(b)
(a)
(B)

Cub Cadet Yanmar SC2400 Specifications

General

Engine Power	24 hp
Transmission Type	Hydrostatic
Fuel Capacity	6.6 gallons
Drive	4WD
PTO	Independent
Hydraulic System	Open center
3-Point Hitch	Category 1
Engine Type	3TNV76 diesel engine