14-14
14. PERIODIC SERVICE
Sc2400 Operator’s Manual
■ Checking the Wheel Bolt Tightening Torque
Avoid injury:
●To prevent possible roll-over of the tractor,
check the rim, hub and wheel bolts before
starting day’s operation.
Before starting day's operation, check tightening
torque of each of the tire wheel bolts and, if
necessary, retighten to the specified torque.
Check the tightening torque after the first 5, 15 and
50 hours and thereafter every 50 hours of operation.
If necessary, retighten to the specified torque.
For the specified torque, refer to the following table.
■ Checking the Inflation Pressure
●ALWAYS keep the tires inflated to the correct
pressure. NEVER exceed the recommended
inflation pressure specified in this Operator's
Manual.
Adjust the front and rear tires to the standard pressure.
Check the tires for fissures and any other damages.
Before loader work, make sure to check the tire
pressure and, if necessary, inflate the tire(s) to the
recommended pressure.
(a) Too high
(b) Standard
(c) Too low
Inflation pressures
WARNING
Front wheel bolt (ft•lb (N•m)) 52 - 59 (70 - 80)
Rear wheel bolt (ft•lb (N•m)) 52 - 59 (70 - 80)
WARNING
Tire size Inflation pressure
(psi(kgf/cm
2
))
Inflation pressure when an implement such as the
front loader has been attached to the front of the
machine (psi(kgf/cm
2
))
Front
18 × 8.50 - 10
20 (1.4) 22 (1.5)
Rear
26 × 12.00 - 12
20 (1.4) 22 (1.5)
3130210
(b)(a) (c)
To Next Page
Loading...
Need help?
General
