Cub Cadet Yanmar SC2400 User Manual

9-3
9. POWER TAKE OFF (PTO)
Sc2400 Operator’s Manual
1. Sit on the operator's seat.
2. Engage the parking brake securely.
(A) Parking brake lever
3. Push in the Power Take Off (PTO) switch to set it
to the OFF position.
(A) Power Take Off (PTO) switch
(a) OFF position
(b) ON position
4. Start the engine.
5. Adjust the engine speed to 1500 rpm or lower.
IMPORTANT:
●In order to reduce any shock at the time of driving
the Power Take Off (PTO), make sure to reduce
the engine speed before turning ON the Power
Take Off (PTO) switch.
6. According to an implement to be used, operate
the Mid- / Rear-Power Take Off (PTO) select
lever.
(A) Mid- / Rear-Power Take Off (PTO) select lever
(a) Operating the Mid-Power Take Off (PTO) alone
(b) Operating the Mid-Power Take Off (PTO) and the
Rear-Power Take Off (PTO) at the same time
(c) Operating the Rear-Power Take Off (PTO) alone
7. Pull up the Power Take Off (PTO) switch to set it
to the ON position.
3014916d
(A)
3014919g
(A)
(a) (b)
3014926
3014919e
(A)
(c)
(a)
(b)

Cub Cadet Yanmar SC2400 Specifications

General

Engine Power	24 hp
Transmission Type	Hydrostatic
Fuel Capacity	6.6 gallons
Drive	4WD
PTO	Independent
Hydraulic System	Open center
3-Point Hitch	Category 1
Engine Type	3TNV76 diesel engine