Cupra FORMENTOR 2024 - Rear Controls; Air Recirculation

Air conditioning
149
Heating, ventilation and cooling
/
the air is regulated automatically and con-
tinuously, as long as there is no detection
of fogging hazard.
Information about the AirCare system
can be found in the Settings submenu .
Manual adjustment of fan speed by tap-
ping or .
OR: by pressing or sliding your nger on
the lines until the desired fan speed is
reached.
In this mode, the system automatically
regulates the interior temperature, fan
speed and air distribution for optimal
thermal comfort. The
mode will de-
activate as soon as manual changes are
made to the fan speed, air distribution,
windscreen demisting or air recirculation.
Fan speed in mode can be set in low,
medium or high by successively tapping
the function button.
iClimate submenu
Submenu where dierent smart and/or auto-
matic functionalities are located, depending
on the version.
Warm hands: automatically adjusts for a
certain time the air conditioning to heat
the steering wheel area.
Cool feet: automatically adjusts for a cer-
tain time the air conditioning to cool the
footwell area.
Defog the windows: automatically ad-
justs for a certain time the air condition-
ing to defog the windscreen.
Warm feet: automatically adjusts for a
certain time the air conditioning to heat
the footwell area.
Fresh Air: automatically adjusts for a cer-
tain time the air conditioning to ventilate
the passenger compartment.
Fast cooling: automatically adjusts the air
conditioning to ventilate the vehicle in-
terior for a certain amount of time.
Rear Submenu
Submenu for the air conditioning in the rear of
the passenger compartment where the follow-
ing functions are found:
When the rear lock is activated on, it is not
possible to adjust the temperature from
the rear zone.
Press to adjust the rear zone tempera-
ture.
Settings submenu
Submenu where the following settings are lo-
cated:
●
Automatic recirculation: to switch automatic
air recirculation on and o ›››page149.
●
Heated steering wheel switched on at start of
journey depending on temperature: Press
to switch the function on/o ›››page152.
Rear controls
Fig.116 In the centre console, rear
section: controls for the rear seats.
Temperature selection
●
Press buttons
1
and
2
›››Fig.116 to ad-
just the temperature of the rear zone.
Air recirculation
Air recirculation mode prevents the am-
bient air from entering the interior.
When the outside temperature is very high,
you can select air recirculation for a short pe-
riod of time to refresh the vehicle interior more
quickly.
For safety reasons, air recirculation is discon-
nected when is pressed or when a sensor
detects that the vehicle's windows may mist
up.