Cupra FORMENTOR 2024 - Main Beam Assist (Light Assist)

Lights
131
Vehicle lighting
When this is done, only the side lights of both
headlights, along with the tail lights, partially
light up.
WARNING
Using turn signals inappropriately, not using
them or forgetting to turn them o can con-
fuse other road users. This could cause an
accident with serious consequences.
●
Always give warning of lane changes, over-
taking or turning manoeuvres by activating
the turn signals well in advance.
●
As soon as the lane change, overtaking or
turning manoeuvre is complete, switch o
the turn signal.
WARNING
Improper use of the main beam can cause
accidents and serious injuries, as it can dis-
tract and dazzle other drivers.
Note
●
When you turn the ignition o without hav-
ing turned the turn signals o, an acoustic
signal sounds while the driver door is open. It
is intended to remind you to turn o the turn
signals, unless you want to leave the parking
light on.
●
If the convenience turn signals are on
(three ashes) and the convenience turn sig-
nal on the opposite side is activated, the ac-
tive side stops ashing and only ashes once
on the newly selected side.
●
The turn signal only works when the igni-
tion is switched on. The turn signals only
work when the ignition is switched on.
●
The main beam can only be switched on
when the dipped beam is switched on.
●
If a trailer turn signal fails, the indicator
light (trailer turn signals) stops ashing, in-
stead of ashing the turn signal at double
speed in the vehicle.
●
In cold or wet weather conditions, the
headlights, tail lights and turn signals may be
temporarily fogged from the inside. This is
normal and has no eect on the service life
of the vehicle's lighting system.
●
The parking light does not activate auto-
matically if the left- or right-hand turn signal
is left on and the ignition is disconnected.
Main beam assist (Light Assist)
The main beam assist automatically prevents
glare from vehicles moving in the opposite di-
rection or ahead in the same direction. In addi-
tion, the main beam assist detects illuminated
areas and disconnects the main beam head-
light when passing, e.g. by populated areas.
Within its limitations, the assist system auto-
matically connects or disconnects the main
beam headlight depending on the environ-
mental and traic conditions, as well as the
speed ››› .
Advanced main beam assistant (LED Matrix)
The advanced main beam assistant provides
maximum illumination of the road and road-
side. At the same time, it avoids dazzling vehi-
cles ahead or oncoming traic.
The system uses a camera to detect other road
users and deactivates certain areas within the
light distribution in a specic manner. If the
system cannot avoid dazzling other road users,
the main beam is switched o completely.
The advanced main beam assistant normally
recognizes illuminated areas such as cities
and deactivates the main beam while driving
through them.
Within the limits of the system, the assistant
automatically switches the main beam on or
o depending on the ambient conditions, traf-
c conditions and driving speed.
The advanced main beam assistant can be
switched on or o in the vehicle settings in the
Infotainment System.