Cupra FORMENTOR 2024 - Operating Conditions; Connection and Disconnection

Driver information
31
Road signs detection system
Limited operation
The traic sign detection system has certain
limitations. The following cases may lead the
system to operate with limitations or not at all:
●
In the case of poor visibility, e.g. in snow,
rain, fog or intense mist.
●
In cases of dazzling, e.g. caused by head-on
traic or by the sun.
●
When driving at high speeds.
●
If the camera is covered or dirty.
●
If the traic signs are partially or totally ob-
structed, e.g. by trees, snow, dirt or other vehi-
cles.
●
In the case of traic signs that do not full
the regulations.
●
In the case of damaged or bent traic signs.
●
In the case of variable messages on over-
head or gantry signs (LED-based variable traic
signs or other lighting units).
●
If the maps on the navigation system are not
up-to-date.
●
In the case of adhesives aixed to vehicles
that depict traic signs, e.g. speed limits on
lorries.
Driving with the speed warning
function
Operating conditions
The speed warning function gives warnings at
speeds above 20 km/h.
Connection and disconnection
Depending on the country, the speed warning
function is always activated when the ignition
is switched on. In this case, the infotainment
system displays an overview of the individual
systems and automatically activated functions
in the input menu.
If desired, you can deactivate the speed warn-
ing manually in the infotainment system:
1.
Open the Assistance systems menu.
2.
Switch the speed warning on or o in the
corresponding submenu.
OR: from the multifunction steering wheel:
1.
Open the assistants menu by pressing but-
ton .
2. Select and switch o the Speed warning.
Activating and deactivating the audible
warning
In the infotainment system:
1. Open the Assistance systems menu.
2. Open the Speed Warning.
3. Activate or deactivate the audible warn-
ing under the corresponding option
›››page39.
Note
The audible warning is activated whenever
the ignition is switched on.
Adjusting the warning thresholds
You can manually adjust the warning thresh-
olds of the speed warning function.
In the infotainment system:
1.
Open the Assistance systems menu.
2.
Open the Speed Warning.
3.
To select the level of the warning thresh-
olds, tap in the Overtaking warning
›››page39 menu option.
Note
When the vehicle's ignition is switched on,
the warning thresholds for the speed warning
are always reset to the default value.