Cupra FORMENTOR 2024 - Front Towline Anchorage; Rear Towline Anchorage

336
Miscellaneous situations
Front towline anchorage
Fig.208 Front bumper on right: remove the
lid.
Fig.209 Right side of the front bumper:
towline anchorage screwed in.
The housing of the removable towline anchor-
age is on the right side of the front bumper
underneath a cover ›››Fig.208.
The towing eye should always be kept in the
vehicle.
Bear in mind the instructions for towing
›››page334.
Fitting the towline anchorage
●
Remove the towing eye from the vehicle tool
kit in the luggage compartment ›››page329.
●
Remove the cover by pressing down on its
base and leave it hanging from the vehicle
›››Fig.208.
●
Screw the towing eye in the housing by
turning it to the maximum anticlockwise
›››Fig.209 , ››› . Use a suitable object
that can completely and securely tighten the
towing eye in its housing.
●
After towing, unscrew the towing eye clock-
wise with a suitable object.
●
Replace the cover and push it in until it clicks
into place.
●
Clean the towing eye if necessary and then
store it in the luggage compartment along with
the other vehicle tools.
NOTICE
The towing eye must always be completely
and rmly tightened. Otherwise, it could
jump out of the housing during towing.
Rear towline anchorage
Fig.210 Rear bumper on right: remove the
lid.
Fig.211 Right side of the rear bumper:
towline anchorage screwed in.
The housing of the screw towing eye is on
the right side of the rear bumper behind a lid
›››Fig.210.