Cupra FORMENTOR 2024 - Emergency Assist; How It Works

Assistant systems
221
Emergency Assist
Troubleshooting
Travel Assist is not available or does not
work as expected
The control lamp switches on yellow. A rele-
vant warning is also displayed on the instru-
ment panel screen.
●
There is a fault in the sensors. Check the
causes and solutions described in the informa-
tion about the ACC ›››page209 or the Lane
Assist ›››page217.
●
There is a fault or a defect. Switch the engine
o and on again.
●
The system limits are exceeded.
●
If the problem persists, consult a specialised
workshop. CUPRA recommends visiting a spe-
cialised CUPRA dealer or any SEAT dealership.
Grip the steering wheel
The warning lamp lights up white and a mes-
sage is then shown on the instrument cluster
screen.
●
You released the steering wheel for a few
seconds. Take hold of the steering wheel and
take control of the vehicle.
Grip the steering wheel
The warning lamp lights up red and a message
is shown on the instrument cluster display. De-
pending on the situation, an audio warning
sounds or the steering wheel vibrates.
●
You have let go of the steering wheel for
a long time, or the system limits have been
reached. Immediately take hold of the steering
wheel and take control of the vehicle.
Travel Assist disconnects automatically
●
Vehicles without Emergency Assist:
You have released the steering wheel for a long
period.
●
There is a fault or a defect. Switch the engine
o and on again.
●
If the problem persists, consult a specialised
workshop. CUPRA recommends visiting a spe-
cialised CUPRA dealer or any SEAT dealership.
The adjustment is interrupted unexpectedly
●
Vehicles without lane departure warning:
You have turned on the turn signal.
Lane change assist is interrupted or unavail-
able
A message about this is shown on the instru-
ment cluster display.
●
The vehicle has stopped detecting lane
markings.
●
You have let go of the steering wheel
●
You are applying too much force to the
steering wheel.
●
You have turned on the turn signal too many
times, or the turn signal lever is stuck.
●
The driving speed is lower than around
85km/h.
●
The vehicle has detected objects in the vi-
cinity that prevent an assisted lane change.
●
You are not on a multi-lane motorway.
Emergency Assist
How it works
Emergency Assist can detect whether the
driver is inactive and can automatically keep
the car in its lane and stop it altogether if nec-
essary. This way the system can actively help
avoid an accident or reduce its consequences.
Emergency Assist uses the same sensors as
Adaptive Cruise Control (ACC) and Lane As-
sist Therefore, carefully read the information
about the ACC ›››page204 and Lane Assist
›››page215 and take into account the limita-
tions of the systems and the indications given
in the information.
Driver intervention prompt
If the emergency assist detects that the driver
is not actively doing anything, he or she is
prompted to take control of the vehicle by
audio warnings and a brief application of the
brake. In addition, a warning is shown on the
instrument cluster display and the volume of
the infotainment system is lowered.