Cupra FORMENTOR 2024 - Connecting and Disconnecting

242
Parking and manoeuvring
●
Due to the screen resolution or light con-
ditions, some items may be blurry or not dis-
played at all. Take care with thin posts, fen-
ces, railings or trees that might not be seen
on the screen and could damage the vehicle.
●
The reverse assist has blind spots where
it cannot see people or objects. Monitor the
vehicle's surrounding area at all times.
●
The system is not a replacement for driver
awareness. Supervise the parking manoeu-
vre and the vehicle's surrounding area at all
times.
●
Do not be distracted from the traic by
looking at the screen.
●
The images are only two-dimensional. Pro-
truding objects or holes in the road, for ex-
ample, are more diicult to detect or may not
be seen at all.
●
Vehicle load modies the representation of
the guide lines. The width represented by the
lines decreases with vehicle load. Pay special
attention to the surroundings when the in-
side of the vehicle of the luggage compart-
ment are loaded.
●
In the following situations, objects or other
vehicles appear to be further away or closer
than they actually are. Pay special attention:
–
If moving from a at surface to a slope
and vice-versa.
–
If the vehicle is heavily loaded.
–
When the vehicle approaches objects
that are not on the ground surface or that
protrude from it. These objects may be
outside the camera angle when reversing.
Note
●
It is important to take great care and pay
special attention if the driver is not familiar
with the system.
●
The reverse assist reference lines disap-
pear when the rear lid is open.
Connecting and disconnecting
Connect the reverse assist
●
With the ignition switched on, select reverse
gear.
●
OR: in the infotainment system select >
Driver assist > Park assist.
Disconnect the reverse assist
●
Drive forward at a speed of at least 15 km/h
(9 mph).
Shown on the display
The system’s functions and representations
may vary depending on the equipment.
The assistant's image view changes when the
factory-tted tow hitch is electronically con-
nected to a trailer ›››page309.
Reverse assist functions and symbols
When the reverse assist is connected, you can
make adjustments using the function buttons.
Some adjustments are equipment-dependent.
Exit the current display
Switch to angle parking ›››page243
Switch to the trailer hitching assistance
function
Switch to cross traic
Adjust the display: brightness, contrast
and colour.
Switch to park assist ›››page232
Display/hide the Park Assist view
Guide lines
Green horizontal lines: extension of the vehi-
cle.
Yellow lines: vehicle path depending on the
steering angle.