Cupra FORMENTOR 2024 - Check after 10 Minutes of Driving

380
Wheels and tyres
NOTICE
Switch o the air compressor after a maxi-
mum of 8 operational minutes to avoid over-
heating! Before switching on the air com-
pressor again, let it cool for several minutes.
Check after 10 minutes of driving
Screw in the inator tube ›››Fig.241
8
again
and check the pressure on the gauge
7
.
1.3bar (19psi / 130kPa) and lower:
●
Stop the vehicle! The tyre cannot be sealed
suiciently with the tyre mobility set.
●
You should obtain professional assistance
›››
.
1.4 bar (20 psi/140 kPa) and higher:
●
Set the tyre pressure to the correct value
again.
●
Carefully resume your journey until you
reach the nearest specialised workshop with-
out exceeding 80km/h (50mph).
●
Have the damaged tyre replaced.
WARNING
Driving with an unsealed tyre is dangerous
and can cause accidents and serious injury.
●
Do not continue driving if the tyre pressure
is 1.3bar (19psi / 130kPa) and lower.
●
Seek specialist assistance.