To Next Page

To Previous Page

9. Select item USB and then select the USB device among

those proposed (e.g. device1):

Data flush status...

Upgrade status:

No upgrade thread active...

Port config:

Communication port not init

Firmware rel.:

Hardware rel.:

PSW Version :

File [*.cfg] :

Printer type:

Select port:

None

File (*.psw):

C:\<device1>.PSW

Select (*.psw): Begin upgrade

Select the system communication port

Available port

Selected port

COM4

COM5

COM6

COM7

COM9

USB

Cancel

Select Printer

Selected Printer

Port filtering...

USB

Cancel

10. After a few minutes a message on the screen warns

that the update is completed.

Upgrade OK

Upgrade succesfully completed.

11.    

release.

Update via USB interface

ATTENTION:

-

tween PC and device must be direct, without the use

of HUB device.

  

disconnect other USB devices.

NOTE: For communication via USB you must install on

PC the device driver available in the download area of

the web site www.custom.biz.

Proceed as follows:

1. Write down the product code (14 digits) printed on the

product label (see paragraph 3.5).

2. Go to the web site www.custom.biz and download the

  

area.

3. Print the setup report (see chapter 6).

4. Switch off the device.

5. Connect the device to the PC using a USB cable (see

paragraph 4.5).

6. Switch on the device.

7. Launch the software UPGCEPRN.

8. W location: