6.5 Ethernet parameters
The parameters marked with symbol
D
are the default values.
Settings remain active even after the device has been turned off and they are stored in non-volatile memory.
DHCP CLIENT Setting of DHCP protocol:
Disabled
D
= protocol disabled
Enabled = protocol enabled
FTP SERVER Setting of FTP server:
Disabled
D
= server disabled
Enabled = server enabled
IP ADDRESS IP address of device; this parameter is assigned by network administrator.
NOTE: Press FORM FEED key to modify the value of highlighted digit.
Pressing LINE FEED key to move cursor on next digit (if cursor is on the latest digit, proceed to next pa-
rameter by pressing LINE FEED key).
SUBNET MASK
NOTE: Press FORM FEED key to modify the value of highlighted digit.
Pressing LINE FEED key to move cursor on next digit (if cursor is on the latest digit, proceed to next pa-
rameter by pressing LINE FEED key).
DEFAULT GATEWAY
NOTE: Press FORM FEED key to modify the value of highlighted digit.
Pressing LINE FEED key to move cursor on next digit (if cursor is on the latest digit, proceed to next pa-
rameter by pressing LINE FEED key).
DOMAIN NAME SYSTEM
-
TCP PRINTER PORT This parameter sets TCP port number.
-
MAC ADDRESS
univocal.
ATTENTION: Any changes to network parameters will interrupt browser connection. If the server not responding you
must reconnect to the new IP address set.
96
To Next Page
Loading...
Need help?
General
