TICKET MANAGEMENT This parameter allows the ticket management:
Disabled
D
= no check
Short Ticket = it is possible to manage tickets with length less than the distance between
notch sensor and printing line
Stub+Ticket = it is possible to manage tickets with stub
PAPER END
MANAGEMENT
KPM302 TF, KPM302 TF-EJ, KPM302 TF-vSEL, KPM302 TF-hSEL, TK302 TF
Management of the paper end sensors of triple feeder:
Print All
D
= when the paper end sensor of a feed line of the triple feeder detects the
paper end, it is not possible to change the feed line until all tickets remain-
ing in that feed line are printed (so that the paper sensors of the printer will
have detected the end of paper)
Eject = when the paper end sensor of a feed line of the triple feeder detects the
paper end, the device automatically ejects the paper remaining on that feed
line and prints diagonal voiding lines on the remaining tickets
Retract = when the paper end sensor of a feed line of the triple feeder detects the
paper end, the device performs a paper retracting up to the parking position
RFID MODULE
BAUD RATE
Communication speed of RFID module:
115200 38400
D
9600 2400
57600 19200 4800 1200
NOTE: if the RFID module is not recognized in the printer status (“RFID module = Not Present”), set this
parameter on the correct value.
PRINT DENSITY Adjusting the printing density:
-50% -12% +25%
-37% 0
D
+37%
-25% +12% +50%
95
To Next Page
Loading...
Need help?
General
