NOTCH DISTANCE [mm x .1] Setting the digit for decimals:
0
D
2 4 6 8
1 3 5 7 9
NOTES:
For example, to set a positive notch distance value of 15mm, modify the parameters as follows:
Notch Distance Sign = +
Notch Distance [mm x 10] = 1
Notch Distance [mm x 1] = 5
Notch Distance [mm x .1] = 0
If the “Notch/B.Mark Position” parameter is disabled, parameters for the “Notch Distance” are not printed.
NOTCH/B.MARK
MIN. WIDTH
Minimum length for the alignment notch:
0 mm
D
5 mm 10 mm 15 mm 20mm
1 mm 6 mm 11 mm 16 mm
2 mm 7 mm 12 mm 17 mm
3 mm 8 mm 13 mm 18 mm
4 mm 9 mm 14 mm 19 mm
NOTES: If the “Notch/B.Mark Position” parameter is disabled, this parameter is not printed.
This parameter describes the dimensions of the alignment notch in order to avoid that other graphics on
ticket is detected erroneously as notch.
TICKET LOCKING
This parameter enables/disables the block of paper inside the device when the ticket is
not cut by the cutter, but is presented for manual tear off by the user:
KPM302 STD, KPM303 STD, KPM302 EJ, KPM303 EJ, KPM302 vSEL, KPM303 vSEL,
TK302 STD, TK303 STD
Disabled
D
= paper block disabled
Enabled = paper block enabled
KPM302 TF, KPM302 TF-EJ, KPM302 TF-vSEL, KPM302 TF-hSEL, TK302 TF
Disabled
D
= paper block disabled
By Printer = the motor remain switched on also at the printing end
By Feeder = stops the paper of the not active (idle) feeders in order to avoid that the
paper parked in a idle feeder, is dragged inside the printer
Complete = ticket locking by printer and feeder (combination of the two previous ef-
fects)
NOTE: If the “Notch/B.Mark Position” parameter is disabled, the parameter is not printed.
PAPEREND BUFFER
CLEAR
Cleaning mode of data in receive buffer, if the printing is stopped due to lack of paper:
Disabled
D
= Data remain in the receive buffer. When the paper runs out, the device
keeps the remaining data in receive buffer and prints the remaining portion
of ticket after that the new paper is loaded.
Enabled = When the paper runs out, all data in the receive buffer are deleted.
94
To Next Page
Loading...
Need help?
General
