Custom Audio Electronics TK303 - Page 179

To set a negative value of the “Notch Distance” parameter is useful in cases where the alignment point refers to the
notch/b.mark on the previous ticket or where the desired cutting line is placed in the middle of the alignment notch/b.mark
(for example, for paper with holes or gap). In the following images, the value of “Notch Distance” parameter is set to -A.
0
PRINTING DIRECTION
-A
0
PRINTING DIRECTION
-A
0
-A
PRINTING DIRECTION
Alignment point
Notch front
Alignment point
Notch front
Alignment point
Notch front
179