CUSTOM/POS emulation
-
tance” parameter (see par. 6.4).
For example, to set a notch distance of 15 mm between the notch/b.mark and the alignment point, the parameters must
be set on the following values:
Notch Distance Sign : +
: 1
: 5
: 0
• during the setup procedure of the device (see chapter 6)
•
• by using the command 0x1D 0xE7 (for more details, refer to the commands manual)
• by driver.
SVELTA emulation
• by using the parameters of the <LHT> command (for more details, refer to the commands manual)
•
• by driver
• “Ticket X Dimension”
• “Ticket Y Dimension”
• “Notch Width”
• “Notch Distance”
PRINTING DIRECTION
“Ticket X Dimension”
Alignment
point
“Notch/B.Mark Distance”
“Notch/B.Mark Width”
181
To Next Page
Loading...
