CVC TECHNOLOGIES, INC. CVC 310 OPERATION MANUAL
5. INSTALLATION PROCEDURES
5.1 Power Connection
a. Connection of electricity supply to the machine is necessary for the operation of its electrical
components.
b. Connect the main power cord of the machine to the safety NFB breakers on the power source,
ensuring that the voltage and amperage meet machine’s requirements.
c. Only use 3-hole socket and properly grounded.
d. Disconnect the machine power immediately if water is on or near the power source of the control
panel.
5.2 Compressed Air Connection (Optional)
Connect the air pressure inlet adapter into the compressed air inlet socket of the machine.
Air pressure
gauge
Air Inlet
Air Outlet
Fig 5.2-1
5 - 1
To Next Page
Loading...