Why is the backing paper being pulled out by the product on my CVC 400?
If the backing paper is being pulled out by the product on your CVC Label Maker, the label dispensing speed is likely too slow. Increase the label dispensing speed.
How to fix unclear printing on my CVC 400 Label Maker?
If the printing on your CVC Label Maker is unclear, consider the following: * Check if the hot stamp silicone pad is worn and replace it if necessary. * Insert two or three pieces of paper behind the label to check the printing quality. If the printing becomes clear, decrease the distance between the type chase and the hot stamp silicone pad. * The hot stamp ribbon may be of poor quality, try another ribbon. * Check the air cylinder of the ribbon advance if the ribbon fails to advance forward. * Ensure the ribbon print face is mounted correctly. * Replace the label material if the ribbon ink fails to print on the label surface.
Why is my CVC Label Maker dispensing two labels at once?
If your CVC Label Maker dispenses two labels at a time, it might be due to: * The sensitivity values of the labels and backing papers being too close, preventing the signal to stop the dispensing. Increase the label sensitivity value. * The red light of the label sensor not emitting exactly on the backing paper. Adjust the emitting point properly. * Some transparent products may cause the product sensor to detect the same product repeatedly. Properly adjust the product sensor.
What to do if my CVC Label Maker has inconstant label extension?
If you are experiencing inconsistent label extension, which leads to incorrect labeling positions with your CVC Label Maker, consider the following: * If the backing paper between the label sensor and label peel blade is loose, tighten the screw on the web clamp. * If it's too tight, loosen the screw on the web clamp. * Ensure the advanced roller lock is fastened. * Adjust the label extension to 3mm if the length is insufficient. * Increase label dispensing speed if it's too low to synchronize with the conveyor. * Tighten the connection screw between the roller guide and stepper motor if it's loose.
Why does my CVC 400 repeatedly dispense the same label?
If your CVC Label Maker is repeatedly dispensing the same label, it could be due to several reasons: * The sensitivity values of the backing paper and labels are too close. Ensure the label sensitivity value is higher than the backing paper's by 30. * The label web is not properly placed in the label sensor slot. Check and ensure it is correctly placed. * If you are using a clear label, use a clear label sensor. * The label edge is exactly placed in the label sensor slot. Increase the label dispensing length.
Why is my CVC 400 Label Maker making abnormal noises?
If you hear abnormal noise when the labeling motor is running on your CVC Label Maker: * The labeling speed may be too fast, causing the stepper motor to overload. Slow down the labeling speed. * There might be insufficient product spacing. Increase the product spacing.
What does it mean if thermal indicator keeps on (red) on CVC Label Maker?
If the thermal indicator on your CVC Label Maker stays on (red) or is flashing, the thermal IC is malfunctioning. Replace it with a new thermal IC.
How to fix label front curl on my CVC 400 Label Maker?
If you are experiencing label front curl on your CVC Label Maker, adjust the labeling position rightward if it is too leftward.
How do I troubleshoot unstable printing on my CVC 400 Label Maker?
If you are experiencing unstable printing performance on your CVC Label Maker: * If there is ink spread, lower the printing temperature. * If the printing is faint, increase the printing temperature.
Why are the labels not aligned on my CVC 400?
If both label sides (left and right) are not aligned on your CVC Label Maker: * An irregular product may cause an incorrect emitting point. Perform detecting point adjustments. * Transparent products may cause incorrect product detection. Decrease the product sensor sensitivity.
General| Brand | CVC |
|---|---|
| Model | 400 |
| Category | Label Maker |
| Language | English |
To Next Page
