CVC 400 - U-Type Spring Clip Mounting (Optional)

CVC TECHNOLOGIES, INC. FRONT/BACK LABELER CVC 400 OPERATION MANUAL
5.3 U-Type Spring Clip Mounting (Optional)
Follow the illustrations given below to mount the U type spring clip before using 38mm label web. It is
designed to fasten the label roll when 38mm label web is applied.
a. Remove the PU wheel from label roll axle and replace it with the U-type spring clip onto the axle.
b. And then load a 38mm label web on the label roll disk to complete the label web mounting.
Label roll
Label roll axle
5 - 2
Label roll dis
k
U-type spring clip
PU wheel
Fig 5.3-1
Label roll axle
Fig
5.3-2