CVC TECHNOLOGIES, INC. CVC 310 OPERATION MANUAL
13 - 1
13. MAINTENANCE
13.1 General Precautions
a. Safety
․Before performing any maintenance job or cleanup, ensure that the power is disconnected.
․Always take the necessary safety measures to protect both machine and personnel when carrying
out maintenance job
b. Machine Clean-up
Use a damp fabric to clean the machine parts; do not wash directly with water. For tough dirt,
moderate flammable products can be used (such as solvent, alcohol for industrial use …etc.), avoid
using highly corrosive or inflammable products (such as methane or thinner …etc.)
c. Spare Parts Replacement
Regularly check the machine for damaged or worn out parts and have them replaced if necessary.
13.2 Sensor Maintenance
All the sensors installed on this machine which do not require any maintenance. We recommend that
you do the following step at regular intervals:
a. Clean the optical interfaces
b. Check the screw connections and plug-in connections
To Next Page
Loading...
