CVC TECHNOLOGIES, INC. CVC 310 OPERATION MANUAL
the indicator is lit and stops flashing if print temperature is more than 329 ℉. The main power of
the printer must be switched off to protect the heater from overheating if the indicator is lit.
i. Trial print:
- By pressing test button on the printer, the cylinder of the brass type holder will perform a
backward and forward stroke and then the data is printed onto the label.
- If the stamped numbers are too thick to read, try decreasing slightly both the print time from the
machine control panel and the temperature heat temp from the printer.
- If the stamped numbers are too faint to read, try increasing slightly both the print time from the
machine control panel and the temperature heat temp from the printer.
- Label material should be considered for making adjustments to achieve better results.
- If a temporary stop is too long, the first stamping after re-starting labeling might get a worse quality.
This is because the foil tape is over heated. Decreasing slightly the temperature is able to solve
this problem.
j. Foil feeding adjustments: Use foil advance adjustment knob to set the foil advancing pace as short
as possible.
- If the foil ribbon becomes loose, adjust control knob and ribbon brake to tighten it.
- Adjust control knob if the ribbon advancing paces are inconsistent.
9 - 7
k. The hot stamp printer can also be switched off from the control panel. Use and keys to
search print function (LCD #6); and then press and keys to switch ON or OFF the hot
stamp printer. Refer to Chapter 8, control panel description for more details on this feature.
To Next Page
Loading...
