CREATING A PRODUCT PAGE 13
Introduce 99 and press the
key.
P 125 P+__ N 99 / 4 CY __
Th: __.__ __.__ Kg/mm²
p/d _/_ CR __/ri __.__
--MEM-- --POS-- --COR--
__._° mes____.__
Y1 ___.__ 350.92 ___.__
Y2 ___.__ 351.05 ___.__
X 1 ___.__ 51.85 ___.__
Q ____ ____
Lmat ____ Fb ___ TON
Rx ___ Ext start _
Vy _ _ ΔT _._s
TDC ___ SP ___
F1:___ F2:___ F3:___ F4:__ F5:__ Cr:__
Introduce the thickness, the sigma, the tools as below:
P 0 P+__ N 1 / 1 CY __
Th: 2.00 σ 37.00 Kg/mm²
p/d 1/1 CR __/ri __.__
Program 90 in the field,
by leaving the field, the system calculates the Y1 and Y2 axes' values.
Introduce 58.0 in the X field (stop position for this first bend).
Introduce the bending length 1000.
The system calculates the pressure and the crowning automatically.
If necessary, introduce the dwell time (by default non-programmed =
0.5 s), the gauge retraction, the bending speed reduction, the slow
raising, etc.
Press the sequence forwards key
, in order to copy this first se-
quence in sequence 2.
The message COPIED is displayed, the N field passes on 2.
The LED of the key remains lighted, indicating that you are on the
last sequence.
To Next Page
Loading...
