ANNEX G: SUNDRIES PAGE 65
X1-X2 safety factor
The safety factors offered for X1 X2 are identical to the ordinary X axis.
The nearest axis (X1 or X2) to the die is taken into account for the safety fac-
tor.
Z1-Z2 safety factor
An anti-collision safety factor prevents the passage to and
modes, and the interactive message "Z1-Z2" is obtained if the positioning is
impossible (see parameter 51).
Normally the origin of the Z axes is on the left of the machine when looking
at the front of the machine.
To Next Page
Loading...
