38D-Link DCS-5220 User Manual
Section 3 - Configuration
Enable UPnP Port
Forwarding:
PPPoE Settings:
HTTP:
Authentication:
HTTP Port:
Secondary HTTP
Port:
Access name for
stream1:
Enables the camera to automatically add the port forwarding entry into the router.
Enable this setting if your ISP (DSL service) is using PPPoE. You may already have both Username and Password given
by your ISP, or you may check with your ISP. The Connect Status will be determined automatically by the system.
You may congure two HTTP ports for your camera. HTTP ports allow you to connect to the camera via a standard
web browser. These ports can be set to a number other than the default TCP ports 80 and 8080. A corresponding
port must be opened on the router. For example, if the port is changed to 1010, users must type in the web browser
“http://192.168.0.100:1010” instead of “http://192.168.0.100”.
Choose either Basic where the password is not encrypted, or Digest where the password is encrypted during the
transmission to the web server.
Note: Restart your browser, if you select Digest mode.
Basic authentication: The password is sent in plain text format; there can be potential risks of being intercepted.
Digest authentication: User credentials are encrypted in MD5 algorithm and thus provide better protection against
unauthorized accesses.
The default value is 80.
The default value is 8080.
After you have enabled the Authentication, you will need to congure and use the access name to access your video le.
For example, http://camera ip/video.mjpg (video.mjpg is the Access name, you can modify it here)
The default name is video.mjpg.
To Next Page
Loading...
Need help?
Operating Environment
Power
Weight and Dimensions
