D-Link DSL-2680 - ADSL Setup - Manual Configuration

22D-Link DSL-2680 User Manual
Chapter 3 - Setup
ADSL Setup - Manual Conguration
To congure the Router’s basic conguration settings without running the Setup
Wizard, you can access the menus used to congure ADSL Setup, Wireless Setup,
and LAN Setup settings directly from the Setup directory. To access the ADSL Setup
menus for PPPoE/PPPoA, Dynamic IP Address, Static IP Address and Bridge Mode
connections, click on the ADSL Setup link button on the left side of the rst menu
that appears when you successfully access the Web manager.
Choose the ADSL connection type used for your service listed under the heading
Manual ADSL Connection Setup, the menu changes according to the type of
connection to be configured. Configure the settings for the chosen Internet
Connection Type. Follow the instructions presented below for the type of connection
used for your ADSL service. The default Internet connection type is PPPoE/PPPoA.
Note: Most users DO NOT need to change conguration settings for the Virtual Circuit at the bottom of this menu. Normally these settings are changed
only for special circumstances and applications. Do not change these unless your ISP has given specic instructions to do so.
For information about these conguration settings, go to “Congure VPI and VCI” on page 27.