D-Link DSL-2740M - Outbound Filter

51D-Link DSL-2740M User Manual
Section 3 - Conguration
Outbound Filter
OUTBOUND IP FILTEROutbound Filter
ADVANCED
Click Outbound Filter on the navigation menu to congure the Outbound Filter. The
Outbound Filter allows you to place ltering rules on a per IP basis. Using this tool you may
restrict access to or block trac to a specic remote IP address or range.
The currently dened Outbound Filter rules are listed here. Click Remove to remove a
dened rule.
ACTIVE OUTBOUND FILTER
Filter Name: Enter a name for this Outbound Filter.
Protocol: Select TCP, UDP, or ICMP from the dropdown menu.
Source IP address: Enter the source IP address.
Source Subnet
Mask:
Enter the source subnet mask.
Source Port: Enter the source port.
Destination IP
address:
Enter the destination IP address.
Destination Subnet
Mask:
Enter the destination subnet mask.
Destination Port: Enter the destination port.
Click the Add/Apply button to add your Outbound IP Filter Rule.
ADD OUTBOUND IP FILTER