DWR-921 4G LTE Router
User Manual
Configuring via Web-based Interface
Parameter Description
Clients isolation
Move the switch to the right to forbid wireless clients of this
wireless network to communicate to each other.
Enable guest network
This function is available for the additional network. Move the
switch to the right if you want the devices connected to the
additional network to be isolated from the devices and resources of
the router's LAN.
In the Security Settings section, you can change security settings of the wireless network.
By default, the WPA2-PSK network authentication type of the wireless network is specified. WPS
PIN from the barcode label is used as the network key.
Figure 119. Network authentication types supported by the router.
The router supports the following authentication types:
Authentication type Description
Open
Open authentication (with WEP encryption for wireless network
modes not supporting 802.11n).
WEP
Authentication with a shared key with WEP encryption. This
authentication type is not available when a mode supporting
802.11n devices is selected from the Wireless mode drop-down
list on the Wi-Fi / Basic Settings page.
WPA WPA-based authentication using a RADIUS server.
WPA-PSK
WPA-based authentication using a PSK.
WPA2 WPA2-based authentication using a RADIUS server.
WPA2-PSK
WPA2-based authentication using a PSK.
WPA/WPA2 mixed
A mixed type of authentication. When this value is selected, devices
using the WPA authentication type and devices using the WPA2
authentication type can connect to the wireless network.
Page 146 of 255
To Next Page
Loading...
