D-Link DWR-922

41D-Link DWR-922 User Manual
Section 4 - Conguration
Check the box to enable routing, then select which routing
protocol to use:
• RIPv1: Protocol in which the IP address is routed
through the Internet.
• RIPv2: Enhanced version of RIPv1 with added
features such as authentication, routing domain, next
hop forwarding, and subnet-mask exchange.
RIP:
The Routing page allows you to specify custom routes that determine how data is moved around your network.
ROUTING RULES
This identies the rule.
Enter in the IP of the specied network that you want to access
using the static route.
Enter in the subnet mask to be used for the specied network.
Enter in the gateway IP address for the specied network.
Enter in the amount of hops it will take to reach the specied
network.
Note: In a transmission path, each link is terminated at a network
device such as a router or gateway. The number of hops equals
the number of routers or gateways that data must pass through
before reaching the destination.
Select this box to enable the rule.
Click Apply to save your settings, or Refresh to revert to your
previous settings.
ID:
Destination:
Subnet Mask:
Gateway:
Hop:
Enable:
Routing