D-Link DWR-922 - Technical Specifications

90D-Link DWR-922 User Manual
Appendix C - Technical Specications
Technical Specications
LTE Band
1
• 800 / 900 / 1800 / 2600 MHz
UMTS/HSDPA/HSUPA/HSPA+/DC-HSPA+ Band
1
• 900 / 2100 MHz
• Power Class 3
GSM Quad-band
1
• 850 / 900 / 1800 / 1900 MHz
Data Rates
2
• Up to 300 Mbps with 802.11n clients
• 6 / 9 / 11 / 12 / 18 / 24 / 36 / 48 / 54 Mbps in 802.11g mode
• 1 / 2 / 5.5 / 11 Mbps in 802.11b mode
• LTE Uplink: Up to 50 Mbps
• LTE Downlink: Up to 150 Mbps
Standards
• 802.11b/g, compatible with 802.11n devices
• 802.3
• 802.3u
Wireless Security
• 64 / 128-bit WEP (Wired Equivalent Privacy)
• WPA & WPA2 (Wi-Fi Protected Access)
Firewall
• Network Address Translation (NAT)
• Stateful Packet Inspection (SPI)
VPN
• L2TP/PPTP/IPSEC/VPN Pass-through
Antenna
• Two detachable 3G/4G antennas
Ports
• Four LAN ports (RJ-45)
• WAN port (RJ-45)
• RJ11 port
USIM Slot
• Standard 6-pin SIM card interface
LED Status Indicators
• Power
• LAN
• WLAN
• 2G / 3G
• 4G
• SMS
• Signal Strength
Dimensions
• 190 x 111.5 x 23.5 mm (7.48 x 4.39 x 0.93 inches)
Operating Temperature
• 0 to 40 ˚C (32 to 104 ˚F)
Operating Humidity
• 10% to 90% (Non-condensing)
Certications
• CE
• Wi-Fi Certied
1
Supported frequency band is dependent upon regional hardware version.
2
Maximum wireless signal rate derived from IEEE Standard 802.11g/b/n specications. Actual data throughput will vary. Network conditions and environmental factors, including volume of network trac, building
materials and construction, and network overhead, lower actual data throughput rate. Environmental factors will adversely aect wireless signal range.