D-Link DWR-922

44D-Link DWR-922 User Manual
Section 4 - Conguration
Select this box to Enable outbound ltering.
Select a schedule to use and copy to the specied rule ID when
you click the Copy to button. You may select Always On or use
a specic schedule that you have dened. To create and edit
schedules, please refer to Schedules on page 60.
OUTBOUND FILTER RULES LIST
Here, you can select whether to Allow or Deny all outgoing trac
except for trac that matches the listed rules.
This identies the rule.
Specify the local IP address and then specify the port after the
colon.
Specify the remote IP address and then the port after the colon.
Check the box to enable the specied rule.
Specify the schedule rule number. Click on the Add New Rule
button to create a new schedule rule.
Go back to the previous lter page.
Advance to the next lter page.
Click Apply to save your settings, or Refresh to revert to your
previous settings.
Outbound Filter:
Use Schedule Rule:
ID:
Source IP : Ports:
Destination IP :
Ports:
Enable:
Schedule Rule #:
Previous Page:
Next Page:
Outbound Filter enables you to control what packets are allowed to be sent out to the Internet. The outbound lter applies to all outbound packets.
Outbound Filter